Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 4
General Information
Lift Roller Position
The cutting unit comes with its lift roller installed in the
top position. The position of the roller may be changed
as follows:
1. Remove hex head screw and lock nut from the lift
roller and frame.
2. Position lift roller to the proper hole on the frame. In-
sert hex head screw through the frame and roller.
Lower Hole − for increased transport height.
Upper Hole − standard transport height so the cut-
ting unit is level when it touches down upon lower-
ing.
3. Secure hex head screw with the lock nut.
1. Lift roller 2. Hex head screw
Figure 15
2
1
To Next Page
Loading...
