Greensmaster 3250−D Page 3 − 7 Engine
Adjustments
Adjust Alternator Belt
Make sure belt is properly tensioned to assure the prop-
er operation of the machine and prevent unnecessary
wear. On new belts, check tension after 8 hours of op-
eration.
The engine belt should be tensioned so it deflects 0.20
inch (5 mm) with a 2 to 3 lbf (9 to 13 N) load applied mid-
way between the crankshaft and alternator pulley.
1. Loosen bolts securing the alternator to the engine
and adjusting bracket.
2. Adjust belt to proper tension and tighten bolts.
Figure 7
1. Bolt 2. Belt
2
1
Adjust Throttle Control
Proper throttle operation is dependent upon proper ad-
justment of throttle control. Make sure throttle control is
operating properly.
1. Move remote throttle control lever to SLOW posi-
tion.
2. Loosen cable clamp screw securing cable to en-
gine.
3. Move cable until speed control lever contacts idle
speed screw
Figure 8
1. Throttle cable
2. Cable clamp
3. Speed control lever
4. Idle speed screw
2
1
3
4
Adjust Idle Speed (Fig. 8)
1. Move remote throttle control lever to SLOW posi-
tion.
2. Loosen lock nut on idle speed screw.
3. Adjust idle speed screw to obtain 1500 RPM.
4. Tighten lock nut.
Engine
To Next Page
Loading...
