Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 13
Adjust Attitude
There are four positions for the front roller brackets.
Position 1: The least aggressive position is used
for very soft and tender turf, or the highest height−
of−cut (Fig. 27).
Height−of−Cut (HOC) Range − 1/8 to 1−1/32 inch
(3.2 to 26mm)
Note: The top frame hole and top bracket hole will
yield Position 2 (standard position).
Position 2: The standard position is used for
most conditions (Fig. 28).
HOC Range − 3/32 to 15/16 inch (2.4 to 24mm)
Position 3: A more aggressive position is used on
firm turf (Fig. 29).
HOC Range − 3/32 to 13/16 inch (2.4 to 21mm)
Position 4: The most aggressive position is
used only on very firm greens or at the lowest
height−of−cut (Fig. 30).
HOC Range − 3/32 to 3/4 inch (2.4 to 19mm)
Note: A more aggressive setting will increase grass
removal and provide a cleaner cut, but may cause in-
creased scalping and marking.
Note: A more aggressive setting will be required to
compensate for reel wear.
Adjusting Attitude
Note: The top of the right front bracket is secured to
the frame with an eccentric bolt, while the left front
bracket is secured with a shoulder bolt (Fig. 31).
1. If the cutting unit is not already removed from the
machine, remove reel motor from the cutting unit and
cutting unit from lift arm (see Cutting Unit Removal and
Installation).
2. Remove lock nuts from the eccentric (shoulder) bolt
and carriage bolt securing both front brackets.
3. Remove eccentric (shoulder) bolt and carriage bolt
from both front brackets and the side plates.
Figure 27
POSITION 1
To Next Page
Loading...
