Toro Greensmaster 3250-D - Groomer Brush

Greensmaster 3250--DGroomer Page 8 -- 18
Groomer Brush
Figure 18
1. Groomer brush shaft
2. Lock nut
3. J--bolt
4. Groomer brush
5. O--ring
20 to 25 in--lb
(2.3 to 2.8 N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
3
1
2
4
2
3
5
The groomer brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
thegroomerbrushusesthesameprocedureasremoval
and installation of the grooming reel (see Grooming
Reel in this section).
Toremovethegroomerbrushfromtheshaft,removethe
locknutandJ--boltfrombothendsofthebrushandslide
thebrushfromtheshaft.When assembling the brush to
the shaft, secure the assembly with J--bolts and lock
nuts. Make sure that the J--bolts are installed with the
threaded portion on the outside of the brush (Fig. 19).
Torque lock nuts from 20 to 25 in--lb (2.3 to 2.8 N--m).
1. J--bolt 2. Lock nut
Figure 19
2
1