Groundsmaster 4000--D/4010--DCutting Decks
Page 8 -- 2
Specifications
MOUNTING: Cutting decks are supported by lift arms
controlled with individual lift switches.
CONSTRUCTION: Deck chamber is welded steel
construction reinforced with channels and plates.
HEIGHT--OF--CUT RANGE: 1” to 5” (25.4 mm to 127
mm) in 1/2” (12.7 mm) increments. Center deck height--
of--cut adjustment is achieved by changing spacers on
castor wheels and adjusting length of deck support
chains. Side deck adjustment requires adding or remov-
ing spacers from the castor f orks, re--positioning the
castor wheel axles in the castor forks and securing the
pivot arms to the correct height--of--cut bracket holes.
DECK DRIVE: Closed loop hydraulic system operates
hydraulic motor on each cutting deck. The motor drives
one spindle directly with remaining deck spindle(s) driv-
en by B section kevlar v--belt(s). Blade spindles are
1.250” (31.7 mm) shafts supported by greaseable, ta-
pered roller bearings.
CUTTING BLADE: Cutting blade dimensions are
21.750” (552 mm) long, 2.500” (64 mm) wide and 0.250”
(6.4 mm) thick. Anti --scalp cup installed on each cutting
blade. Three (3) blades on front deck and two (2) blades
on each side deck.
WIDTH OF CUT: Center deck provides 62” (1575 mm)
width o f cut. Each side deck has 42” (1067 mm) width of
cut. Total width of cut is 132” (3353 mm) with 7” (128
mm) overlap.
DISCHARGE: Clippings are discharged from the rear of
the cutting decks. Provided mounting holes allow at-
tachment of optional Guardian Recycler Kit.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Center deck suspended
at rear from lift arms and has two (2) castor wheels, two
(2) adjustable skids and two (2) anti--scalp rollers. Each
side deck supported by three (3) castor wheels and a
spring damper system which connects the fourth deck
corner to the traction u nit. There is a main lift arm that
provides counterbalance to the side decks along with a
rear anti--rotation link which also provides bi--directional
impact protection. Optional Guardian Recycler Kit in-
cludes one anti--scalp roller on each cutting deck.
To Next Page
Loading...
