Groundsmaster 4010--D Operator CabPage 9 -- 13
Disassembly (Fig. 10)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. If access to wiper motor is necessary, remove fasten-
ers that secure roof in place. Raise and support r oof to
allow access to condenser assembly (see Roof Assem-
bly in this section).
3. Remove windshield wiper components as needed
using Figure 10 as a guide.
Assembly (Fig. 10)
1. Assemble windshield wiper components using Fig-
ure10asaguide.
2. If roof was raised, lower and secure roof assembly
(see Roof Assembly in this section).
Operator
Cab
To Next Page
Loading...
