16
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Description Qty. Use
Deck tilt link
Klik pin
1
2
Securing the front cutting unit in a vertical
position for service (shipped in the tool box)
Adjusting screw
Nut
1
1
Use when replacing front cutting unit blade
drive belt
Height gauge 1
Use when replacing front cutting unit blade
drive belt
Diagnostic ACE overlay 1 Troubleshooting aid
Parts Catalog 1 Ordering service parts.
Operator’s manual 2
Read and understand before operating the
machine.
Operator Video 1
View and understand before operating the
machine.
Checking the Batteries
1. Unlatch the hood and left hand engine side panel
(Fig. 1). Raise and prop hood open and remove the left
side panel. Make sure hood prop is secured in one of the
mounting brackets on hood.
1
2
3
4
Figure 1
1. Engine hood
2. Left side panel
3. Hood latches
4. Side panel latch
2. Remove the capscrews securing the battery tray and
slide the tray out (Fig. 2).
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning
Battery terminals or metal tools could short
against metal tractor components, causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
• Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
Warning
To Next Page
Loading...
