26
Engine Override Switch
If engine has overheated and been shut–down by the safety
switch, depressing button (Fig. 20 and 21) will allow
engine operation. Use button only for emergencies and only
at short intervals.
1
Figure 21
1. Engine override switch
Electrical System—Fuse Blocks
The electrical system is protected by fuses which are
located under the control panel to the operator’s right
(Fig. 22). Fusible links are also incorporated into the wire
harness for the protection of the entire wiring circuit. The
links can be replaced if total loss of electrical function
results. However, the reason for the malfunction should
first be found and corrected.
1
2
Figure 22
1. Fuse block (2) 2. Fusible link
Traction Pedal
The traction pedal (Fig. 23) controls forward and reverse
operation. Depress top of pedal to move forward and
bottom to move in reverse. Ground speed is dependent
upon high range/low range ground speed mode(slower in
low than high range) and proportionate to how far pedal is
depressed.
Steering/Parking Brake Pedals
The left and right turn pedals are connected to the front
wheel brakes (Fig. 23). Since both brakes work
independently, they can be used to turn machine more
sharply or to increase traction if one wheel tends to slip
while operating on a hillside. However, wet grass or soft
turf can be damaged when brakes are used for turning. A
brake latch lever locks the two pedals together for parking.
Whenever the engine is shut off, set parking brake to
prevent accidental machine movement. Latch pedals
together, depress them and pull the parking brake knob at
the top of the steering tower up (Fig. 19) Depress brake
pedals to release the parking brake.
1
2
4
3
Figure 23
1. Traction pedal
2. Brake pedal
3. Steering/Parking brake
pedals
4. Brake latch lever
Brake Pedal
Single pedal (Fig. 23) operated by the right foot actuates
fully enclosed, multiple disc front brakes.
Note: There is dynamic braking through the closed-loop
hydrostatic traction drive system.
Storage
A large removable tool storage tray is located under a
hinged floor plate (Fig. 24). A small storage and beverage
holder is to the operator’s right.
To Next Page
Loading...
