Toro Hydroject 3000 - Aeration Operation; Operating Procedures and Safety

TORO Hydroject® 3000/4000 Components
NOTES
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
____________________________________________________________________________________________________________
15
Traction Linkage (3000 Hydroject® Only)
The traction linkage connects the traction bail to the swash plate. During aeration, a steel cable pulls the left link
toward the hole spacing lever, limiting swash plate movement to the required speed. In this mode, the hole
spacing lever is spring-loaded and will snap towards the key switch when removed from the indexing latches.
NOTE: Do not adjust hole spacing with out lowering the unit.
Control Panel (3000 Hydroject® shown)
The control panel controls or monitors the Hydroject® functions. The controls, (from right to left) include:
hourmeter, throttle, hole spacing lever, ignition key switch, 20 amp circuit breaker reset, inlet water pressure
gauge, spray roller wash knob and choke.