Toro LoRa Tempus Air CT - Wiring and Sensor Configuration; Connect Solenoids and Master Valve; Configure Rain or Flow Sensor

Toro Tempus Air CT
WIRING
Step 4
1. Connect the Tempus Air CT to the solenoids as described below. Use 9V pulse valves only.
+S- C P 1 2 3 4 5 6 C
2. You can connect on the P output a master valve or a Pump Start Relay. The output will automatically start 2s
before the start of each station.
+S- C P 1 2 3 4 5 6 C
SET SENSOR
Step 5
Warning, by default there are no sensor configured.
The Tempus Air CT has a + S - sensor input on which you can connect a rain sensor or a flow meter/water
meter or pressure switch after cutting the blue wire. Once the sensor is connected, it is necessary to configure
it in the application.
1. Using the MyToroTempus mobile app, connect to your Tempus Air CT via Bluetooth.
2. Click on Add Sensor.
3. Select your sensor type and follow the instructions given by the application
Rain Sensor
4