Toro 24 User Manual

Intelli-Sense
User’s Guide
TIS3348A 4/23/07 3:12 PM Page i
Professional Controllers
12-, 24-, 36-, and 48-Station Models
TIS-PRO

Toro 24 Specifications

General

Stations	24
Rain Delay	Yes
Manual Watering	Yes
Display	LCD
Mounting	Wall mountable
Power Source	24VAC Transformer (included)

Summary

Chapter 1 Getting Started

Controller Hardware Overview

Control Module Overview

Chapter 2 Controller Setup

Set Controller Clock

Instructions for setting the current date and time on the controller.

Set Time Zone

Procedure for selecting the correct time zone for the controller's operation.

Select Auto Daylight Savings Option

Configuration to enable or disable automatic adjustment for Daylight Saving Time.

Set Maximum Active Station Count

Setting the total number of stations the controller will manage for irrigation.

Select Stack or Overlap Option

Choice between sequential station operation (Stack) or simultaneous (Overlap).

Set Master Valve/Pump Start Option

Configuring the dedicated output for master valve or pump start control.

Assign Pump Start Output

Designating a specific station output to control the pump start.

Set Runtime Valve Test Option

Enabling a test to detect short-circuit conditions in station valves.

Set Maximum Backup ET

Setting a fallback ET value for when daily ET data is not received.

Chapter 3 Set Program Schedule

Select Program

Choosing which program (A, B, C, or D) to configure for watering schedules.

Set Program Start Time and Water Window

Defining the start times and duration for watering cycles within a program.

Set Program Water Day Mode

Selecting the watering day schedule mode (e.g., Optimized, Odd/Even, Interval).

Chapter 4 Station Data Setup

Station Setup Mode: Automated by WeatherTRAK

Setting up stations using automated ET data and pre-defined parameters.

Station Setup Modes: User Defined

Setting up stations with user-defined parameters, with or without ET control.

Chapter 5 Support Functions

Using the Review Function

Accessing and reviewing current station and flow monitoring information.

Using the Copy Function

Restoring STATION Default Settings

Restoring PROGRAM Default Settings

Restoring SETUP Default Settings

Using the % Adjust Function

% Adjust by Day Frequency/Maximum Allowable Depletion

Using the Alerts Function

Using the Flow Monitor Function

Set Station Exclusion

Edit Flow Sensor K Value and Offset

Set Threshold and Delay Values

Setting the No Flow Threshold

Setting the Leak Detection Threshold

Using the Reports Function

Using the Rain Pause Function

Using the ET Function

Using the Help/Information Function

Using the Manual Watering Function

Appendix A Troubleshooting Guide

Appendix C Installation Procedures

Selecting the Installation Site

Mounting the Controller

Installing Conduit

Connecting the Power Wires

Procedures for safely connecting the controller to the AC power source.

Connecting an Earth Ground Source

Steps for properly grounding the controller to an earth ground device.

Connecting the Station Wires

Wiring instructions for connecting station valves and common wires to the controller.

Toro Rain Sensor Connection

Flow Sensor Connection

Toro TMR-1 Handheld Remote Connection