Using the Copy Function
Copying Station Information
1. Turn the Function dial to COPY to view the following
display:
2. Turn the Upper Line knob to select the source station number.
3. Turn the Lower Line knob to select the destination station number.
To select All Stations, turn the Lower Line knob one stop past the
highest station number, as shown in the following display:
COPY FROM STA 01 TO
STA 02 (Press Button)
The Copy function provides a convenient method of transferring
all watering program information from one station to another or to
all active stations simultaniously. Minor changes can then be made to
each station as needed, greatly simplifying the process of programming
several stations with similar watering progam attributes.
The Copy function also serves as a means of quickly resetting all user-
defined Setup, Schedule and Program settings back to the factory-default
values. The default values can be reapplied to selected stations or all
stations simultaniously as needed.
4. Press and hold the Copy button. Release the button when
Copying... Done! is displayed.
COPY FROM STA 01 TO
ALL STA’s (Press COPY)
COPYING...DONE!
Note: The number of active stations defined in the Setup function,
determines the number of stations that can be selected.
40
To Next Page
Loading...
Need help?
General
