The following checklist provides the basic steps required for
Intelli-Sense Professional Controller installation, setup,
programming and operation.
Thoroughly inspect the irrigation system for proper design,
installation and operating condition, leaks, as well as broken
heads and pipes. The performance of your new controller
depends on the integrity of the irrigation system design and
installation. You will maximize the performance of your
controller when the irrigation system is well maintained.
Install per the provided intallation instructions. (See Installation
Instructions beginning on page 69).
Fill out the Intelli-Sense Control System Profile spreadsheet with
as much accurate detail as possible. Have the spreadsheet on
hand when performing the controller setup and programming
procedures.
Program the controller. This manual provides step-by-step
instructions for programming the controller based on the infor-
mation captured on the System Profile spreadsheet.
Activate the WeatherTrak ET Everywhere subscription service.
This necessary and important step enables the Intelli-Sense to
receive daily ET updates.
To Next Page
Loading...
