The Run Function
The Off Function
Aug 08 2007 10:58:42am
ON A:02 B: U: M:
Aug 08 2007 10:58:42am
ON A: B: U: M:02
Aug 08 2007 10:58:42am
Irrigation is Turned OFF
1. Turn
The current date and time will be displayed on the upper line.
The lower line will indicate any station number, i.e., station
Station 02 in Program A, is currently operating automatically.
If Station 02 was running manually the display would be shown:
the Function Selector knob to RUN
to view the following
display (example):
Note: When operation of the master valve/ pump start circuit is
enabled within the Setup function, it will be energized in conjunction
with any watering activity. A separate indication for master
valve/pump operation is not shown on the display.
RUN is the Function dial position for normal controller operations.
However, automatic controller operation will occur when the
Function Selector knob is in any position other than OFF.
All controller output will be terminated and remain off while the
function dial is in the OFF position. All other controller operations,
including ET data download, will be uninterrupted.
To Next Page
Loading...
Need help?
General
