Toro Multi-Pro 5700 User Manual (English)

Other manuals for Toro Multi-Pro 5700

Operator's Manual76 pages

Installation Instructions34 pages

Installation4 pages

Questions and Answers:

E
Emily ThorntonSep 10, 2025
How to troubleshoot a Toro Paint Sprayer engine that won't idle?
- M
  Mary PerezSep 10, 2025
  If your Toro Paint Sprayer engine does not idle, try replacing the fuel cap, as the fuel tank vent may be restricted. Also, make sure there is no dirt, water, or stale fuel in the fuel system by draining and flushing it and adding fresh fuel. If the air cleaner element is dirty, replace it. For issues related to the fuel pump or low compression, it is best to contact your Authorized Service Dealer.
R
ronald20Aug 25, 2025
What to do if a boom section of my Toro Multi-Pro 5700 Paint Sprayer does not spray?
- W
  whitneywilliamAug 25, 2025
  If a boom section isn't spraying, start by checking the electrical connection on the boom valve; it might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector, clean all leads, and then reconnect it. Also, check the fuses and replace them as necessary. Look for a pinched hose and repair or replace it. Ensure the boom by-pass valves are properly adjusted.
C
carlosromeroAug 25, 2025
What to do if a boom valve is leaking on my Toro Multi-Pro 5700 Paint Sprayer?
- C
  Claire SmithAug 26, 2025
  If a boom valve is leaking, stop the spray system and pump, and turn off the sprayer. Disassemble the valve and replace the O-rings, as one may be deteriorated.
M
Mario ChaneyAug 26, 2025
Why are there leaks at the fittings of my Toro Paint Sprayer?
- B
  Bethany LeeAug 26, 2025
  Leaks at the fittings of your Toro Paint Sprayer can occur if the fittings are damaged; check for cracks and replace the fitting if necessary. Another cause can be worn thread sealant; if a leak occurs on the threads, disassemble and seal the joint with joint seal compound.
J
Jennifer HendersonAug 27, 2025
How to fix no rinsing or flushing action in my Toro Multi-Pro 5700 Paint Sprayer?
- W
  William ArmstrongAug 27, 2025
  If your Toro Paint Sprayer has no rinsing or flushing action, it could be because the bottle rinse nozzle is plugged or clogged; disassemble the rotary portion of the nozzle from the lower valve assembly and back flush until the nozzle ports are clear of debris. Alternatively, the flush tee might be plugged or clogged; disassemble the flush tee and clean until the nozzle ports are clear of debris.
T
Tammy HallSep 6, 2025
What to do if the engine cranks but doesn't start on my Toro Paint Sprayer?
- J
  Jimmy MontoyaSep 6, 2025
  If your Toro Paint Sprayer engine cranks but doesn't start, the fuel tank might be empty; if so, fill it with fresh fuel. Alternatively, there might be dirt, water, or stale fuel in the fuel system, requiring you to drain and flush the system before adding fresh fuel. Another potential issue is a clogged fuel line, which would need cleaning or replacement. For problems with the kill relay or starter switch, contact your Authorized Service Dealer.
L
lopezbrittanySep 5, 2025
What to do if my Toro Paint Sprayer will not operate or is sluggish because the engine bogs down or stalls?
- R
  robertbeckerSep 5, 2025
  If the machine will not operate or is sluggish because the engine bogs down or stalls, release the parking brake, as it may be set.
L
Larry AustinSep 5, 2025
Why won't the starter rotate the engine on my Toro Paint Sprayer?
- S
  Sarah AndersonSep 5, 2025
  If the starter on your Toro Paint Sprayer isn't rotating the engine, it could be due to several reasons. First, check for corroded or loose electrical connections and ensure they make good contact. Also, inspect the fuse to see if it's blown or loose, and correct or replace it if necessary. If the battery is discharged, try charging or replacing it. For issues related to a broken starter, starter solenoid, or seized internal engine components, it is best to contact your Authorized Service Dealer.
P
Pamela LopezAug 31, 2025
Why does my Toro Multi-Pro 5700 engine will not idle?
- M
  Misty DoyleAug 31, 2025
  If the engine won't idle, the fuel tank vent might be restricted, so replace the fuel cap. Another possibility is dirt, water, or stale fuel in the fuel system, so drain and flush the fuel system and add fresh fuel. The air cleaner element may also be dirty, so clean or replace it.
E
Emily HarrisonAug 30, 2025
What to do if my Toro Multi-Pro 5700 engine cranks but will not start?
- T
  Tami SullivanAug 30, 2025
  If the engine cranks but won't start, first ensure the fuel tank is filled with fresh fuel. If that's not the issue, there might be dirt, water, or stale fuel in the fuel system, so drain and flush the system and add fresh fuel. Additionally, check for a clogged fuel line and clean or replace it if necessary.