Toro Multi Pro 5800 - Operation; Think Safety First; Performing Pre-Starting Checks; Preparing to Drive the Machine

g037014
Figure54
1.License-platelight
3.Bulletconnector(labeled
LICENSELIGHT)
2.Socket
2.Alignthelensforthelightdownandtheholes
inthelightwiththeholesinthelicense-plate
bracket(Figure55).
g037015
Figure55
1.License-platelight
3.Screw(#10x5/8inch)
2.Locknut(#10)
4.License-platebracket
3.Assemblethelighttothebracket(Figure55)
withthe2screws(#10x5/8inch)and2locknuts
(#10).
Note:Ensurethatthewiresarenotpinched
betweenthelightandthelicense-platebracket.
9
AssemblingtheTaillights
Partsneededforthisprocedure:
1Taillightbracket
4
Flange-headbolt(5/16x1inch)
4
Flangelocknut(5/16inch)
2Reartaillamp
3
Cabletie
InstallingtheTaillightBrackets
1.Aligntheholesinthetaillightbracketwiththe2
holes8mm(5/16inch)inthetrussofthecenter
spraysection(Figure56).
g207457
Figure56
1.Flange-headbolt(5/16x
1inch)
3.Hole—truss(centerspray
section)
2.Flangelocknut(5/16inch)4.Taillightbracket(right
bracketshown)
2.Assemblethetaillightbrackettothetruss(Figure
56)with2angeheadbolts(5/16x1inch)and
2angelocknut(5/16inch).
3.Torquetheangeheadboltsandangelocknuts
to1978to2542N∙cm(175to225in-lb).
4.Repeatsteps1through3forthetaillightbracket
attheotherendofthecenterspraysection.
22