Toro Multi Pro 5800 - Checking the Coolant Level

InstallingtheTaillights
1.Removethe2nuts(5mm)fromeachoftherear
taillights(Figure57).
Note:Donotremovethejamnuts.
g207346
Figure57
1.Reartaillamp
3.Screw(5x16mm)
2.Jamnut(5mm)4.Nut(5mm)
2.Assemblethetaillamptothetaillightbracket
(Figure58)with2lockwashersandthe2nuts
(5mm).
Note:Aligntheambercoloredlensoftherear
taillampoutward.
g207345
Figure58
1.Amberlenshalf4.Lockwasher—split(5mm)
2.Outward5.Taillightbracket(right
shown)
3.Nut(5mm)6.Screw(5x16mm—rear
taillamp)
3.Torquethenutsto972to1198N∙cm(51to63
in-lb).
4.Connecttheturnsignalelectricalconnectors
(Figure59)asfollows:
•Connectthe4-socketconnectorofthekit
wireharnesslabeledRIGHTTURNSIGNALto
the4-pinconnectoroftherighttaillightlead.
•Connectthe4-socketconnectorofthekit
wireharnesslabeledLEFTTURNSIGNALtothe
4-pinconnectorofthelefttaillightharness.
g024730
Figure59
1.Taillight
3.4-pinconnector(kitwire
harness)
2.4-socketconnector
(taillightharness)
5.Repeatsteps1through3forthetaillightatthe
otherendofthecenterspraysection.
6.Securethewireharnesstrunk,89cm(35inches)
wireharnessbranch,71cm(28inches)wire
harnessbranchwith3cabletiesasillustrated
inFigure60.
g208462
Figure60
1.Cableties
23