Toro Power Clear 621 - 21 Inch Shroud Removal

CHASSIS
3-16
Toro Single Stage Snow Service Manual
21 Inch Shroud Removal
1. Remove key from ignition. Remove the bolts that hold
the discharge chute to the chute seal ring
(Fig. 017).
2. Remove the single screw holding the chute seal ring
Remove the ring (Fig. 018).
Fig. 017
3. Remove the two rear screws holding the shroud to
the chassis. Remove the two front screws holding the
shroud to the chassis (Fig. 019).
4. Remove the shroud (Fig. 020).
Fig. 018
Fig. 019
Fig. 020