SPECIFICATIONS & MAINTENANCE
2-7
Toro Single Stage Snow Service Manual
Specications & Maintenance
2
Changing the Engine Oil
Service Interval
After the rst 2 hours yearly.
Run the engine a few minutes before changing the
oil to warm it. Warm oil ows better and carries more
contaminants.
1. Ensure that the fuel tank is not overlled and that the
fuel cap is securely in place.
2. Move the machine to a level surface.
3. Place an oil drain pan under the oil drain plug
(refer to page 217), remove the oil drain plug, and tip
the machine backward (handle down) halfway to the
ground to drain the used oil into the oil drain pan.
IMPORTANT
Do not tip the machine all the way back to the ground, or
fuel may leak out of the machine.
4. After draining the used oil, return the machine to the
operating position.
5. Install the oil drain plug and tighten it securely.
6. Clean around the oil ll cap.
7. Unscrew the oil ll cap and remove it.
8. Slowly pour oil into the oil ll hole. Wait 3 minutes,
then check the oil level on the dipstick by wiping the
dipstick clean and then inserting, but not screwing in,
the oil ll cap into the hole.
NOTE
To determine the proper oil level on the dipstick, refer
to Fig. 002.
Inspecting the Rotor Blades
Service Interval
Yearly – Inspect the rotor blades and replace the rotor
blades and scraper if necessary.
Before each session, inspect the rotor blades for wear.
When a rotor blade edge has worn down to the wear
indicator hole, replace the rotor blades and the scraper
(Fig. 001).
A. The wear indicator hole is intact; you do not need to
replace the rotor blades.
B. The wear indicator hole is exposed; replace the rotor
blades and scraper.
Fig. 001
To Next Page
Loading...
Need help?
General
