Toro Power Clear 621 - Engine Installation 18 Inch Models

ENGINE MOUNTING
5-5
Toro Single Stage Snow Service Manual
1. Insert the engine into the chassis. Install the four
engine mounting bolts that connect the engine to the
side plate (A). Torque to 14-18 ft-lbs (19-25 Nm)
(Fig. 007).
2. From the underside of the chassis, install the two
engine mounting bolts (A). Torque to 14-18 ft-lbs
(19-25 Nm) (Fig. 008).
Fig. 007
Fig. 008
A
A
Engine Mounting
5
Engine Installation 18 Inch Models
3. Install the engine pulley. Torque bolt to 19 ft-lbs
(26 Nm) (Fig. 009).
4. Install the belt as outlined in chapter 2. Install belt
cover. Install shroud as outlined in chapter 2.
Fig. 009