Toro power max 826 OXE - Checking and Adjusting the Traction Cable; Checking and Adjusting the Auger;Impeller Cable

CheckingandAdjustingthe
TractionCable
ServiceInterval:Aftertherst2hours—Inspectthe
tractioncableandadjustitifnecessary.
Yearly—Inspectthetractioncableandadjustor
replaceitifnecessary.
Ifthemachinedoesnotdriveintheforwardorreversespeeds
oritdriveswhenyoureleasethetractionlever,adjustthe
tractioncable.
Withthetractionleverdisengaged,checkthepininthe
elongatedslotintheleftsideofthemachineabovethetire.
Thereshouldbeagapof1to1.5mm(1/32to1/16inch)
fromthefrontoftheslottothefrontedgeofthepin(Figure
45).
Figure45
1.Pin
2.1to1.5mm(1/32to1/16inch)
Ifthelefthand(traction)cableisnotproperlyadjusted,do
thefollowingsteps:
1.Loosenthejamnut.
2.Loosenortightentheturnbuckletoadjustthepinuntil
itisthepropergapfromthefrontedgeoftheslot.
3.Tightenthejamnut(Figure46).
Figure46
1.Jamnut2.Turnbuckle
CheckingandAdjustingthe
Auger/ImpellerCable
ServiceInterval:Aftertherst2hours—Inspectthe
auger/impellercableandadjustitif
necessary.
Yearly—Inspecttheauger/impellercableandadjust
orreplaceitifnecessary.
1.Removethe2screwsfromtherightsideofthebelt
coverasshown.
2.Liftuptherightsideofthebeltcover(Figure47).
Figure47
3.Withtheauger/impellerleverdisengaged,ensurethat
thegapbetweentheaugerclutchassemblyandthetab
is1.5mm(1/16inch)asshowninFigure48).
Figure48
1.Tab
2.1.5mm(1/16inch)
4.Iftheauger/impellercableisnotproperlyadjusted,do
thefollowingsteps:
5.Loosenthejamnut(Figure49).
22