g459225
Figure 18
4. T o unfold the handle, refer to 2 Unfolding the Handle ( page 9 ) .
Storing the Machine in the
V ertical-Stow Position
Y ou can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to Adjusting the Cutting Height
( page 13 ) .
3. Disengage the handle locks ( Figure 19 ).
g459226
Figure 19
4. Fold the handle fully forward; refer to Folding
the Handle ( page 18 ) .
Important: Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space ( Figure 20 ).
g251586
Figure 20
19
To Next Page
Loading...
