EasyManua.ls Logo

Toro REELMASTER 4500-D - Maintenance; Service Intervals; Service Specifications

Toro REELMASTER 4500-D
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service Intervals
Check Parking Brake Operation Daily
Check Interlock Switch Operation Daily
Check Engine Oil Level Daily
Check Cooling System Fluid Level Daily
Check Reel-to-bedknife Contact Daily or as required
Check the hydraulic System Fluid Level Daily
Check the tire Pressure Daily or as required
Drain water from fuel separator Daily or as required
Clean Debris From the radiator & Front Grill Daily or as required
*Grease Five (5) Lift Arm Pivot Pins Daily
*Grease Cutting Unit Rollers Daily
*Grease Cutting Unit Reel Bearings Daily
*Grease Rear Axle (3 fittings Daily
Service Air Filter Bowl, Dust Cup & Baffle Daily or as required
Grease Floatation or Fixed Head Pivots and Reel
Control Valve Weekly
Check Cooling System Hoses & Connections 100 hours
Check Condition & Tension of the engine Belts **100 hours
Check Battery Fluid & Cable Connections 100 hours
Change Engine Oil or Filter **100 hrs
Check the hydraulic Lines & Hoses 100 hrs
Drain Water From the hydraulic Reservoir 100 hrs
Tighten Wheel Nuts **200 hrs
Clean Air Cleaner Filter Element **200 hours or as required
Check the engine Valve Clearance **Annually/500 hrs
Replace the fuel Filter 500 hours or as required
Change Planetary Gear Lube **Annually/800 hrs
Change the hydraulic System Filter **Annually/800 hrs
Check Rear Wheel Toe-In &
Pack the Rear Wheel Bearings Annually/800 hrs**
Drain & Flush the Cooling System Annually/800 hrs
Change the hydraulic System Breather Annually/800 hrs
Drain Water From the fuel Tank Annually/800 hrs
Replace Air Cleaner Filter Element Annually/800 hrs
Torque Cylinder Head Bolts **Annually/1,000 hrs
Change the hydraulic Oil 2 years
Replace the seat Switch 2 years
Replace Hand Brake Switch 2 years
Replace the mow-Backlap Switch 2 years
Use #2 Lithium Base Grease. Initial Service Interval—50 operating hours.
Service Specifications
Engine Oil: All temperatures use SAE 10W30 SF, CD.
Hydraulic System Fluid: Refer to Hydraulic Oil Specifications (Page 8). Do not use the engine oil in the hydraulic system.
Filters: Hydraulic Oil (Toro part no. 58-6610); Air (Toro part no. 27-7110); Fuel (Toro part no. 60-5420); Engine Oil (Toro
part no. 49-2500); Hydraulic Reservoir Breather (Toro part no.68-6150.
*No 2 Lithium base grease ** Initial Service Interval—50 operating hours
Maintenance

Related product manuals