Toro Reelmaster 5510 - Page 632

InstallingtheIdlerAssembly
1.Iftheshields,bearing,orbushingwasremovedfromtheidlerarm,install
newcomponentsasfollows:
A.Pressthebushingintoagroomerplateuntilthebushingiscenteredin
theidlerarmbore.
B.Pressthebearingintotheidlerarmsothatthebearingcontactsthe
shoulderinidlerarmboreandinstallthebearingretainingring.
C.Installthebearingshieldswithockedsideofshieldtowardthebearing.
D.Checktheidlerarmorientation(leftorrightcuttingunit)andinsertthe
stubshaft(item8inFigure396)throughshieldsandbearing.Usethe
throughholeintheshafttopreventshaftfromrotating,tightentheange
nutto37to45N∙m(27to33ft-lb).
E.Ifthecollarwasremovedfromtheidlerarm,installthecollarandtighten
to33to41N∙m(24to30ft-lb).
g220504
Figure397
1.Pivothub
2.Applyanti-seizelubricanttotheoutsidediameterofthepivothub(Figure
397).Positiontheidlerarmoverthepivothub.
3.ApplyLoctitetothe2socket-headscrewsandsecurethepivothuband
idlerarmtothecuttingunitsideplate.
4.Installanewcotterpinandclevispinandsecuretheheightadjustmentrod
tothefrontoftheidlerarm.
5.Installthehydraulicreelmotortothecuttingunit;refertoInstallingthe
HydraulicReelMotor(page9–17).
UniversalGroomer(Optional):ServiceandRepairs
Page11–12
Reelmaster
®
5410/5510/5610Series
15216SLRevC