Reelmaster 6500–D/6700–D
Page 4 – 85
Hydraulic System
11. Put the drive plate on a clean lint–free surface with
the eleven tapped holes facing up. Put the rotor set on
top of the drive plate with the five pin holes facing up. Ro-
tate the stator until the eleven hex socket head screw re-
lief slots are aligned with the tapped holes in the drive
plate (Fig. 91).
12. Apply a small amount of clean multi–purpose
grease to the spacer and insert it into the drive slot in the
rotor (Fig. 92). The grease will aid in retaining the spacer
during other assembly procedures.
13. Put the commutator on top of the rotor. Be sure the
correct surface (Fig. 93) is towards the rotor.
Figure 91
Figure 92
Figure 93
Hydraulic
System
To Next Page
Loading...
