Reelmaster 6500–D/6700–D
Page 4 – 86
Hydraulic System
14. Align the five holes and press the five alignment pins
in place (Fig. 94).
IMPORTANT: Make sure the five alignment pins are
pressed below the surface of the commutator.
15. Put a few drops of oil into each recess in the commu-
tator (Fig. 95).
16. Put the commutator ring (either side up) on top of the
stator (Fig. 96). Align the commutator ring screw re-
cesses with the stator screw slots.
Figure 94
Figure 95
Figure 96
To Next Page
Loading...
