Toro TimeCutter 6000 User Manual

48 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FormNo.3436-432RevA

TimeCutter

®

6000RidingMower

ModelNo.75760—SerialNo.400000000andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3436-432*A

Table of Contents

Questions and Answers:

Y
ydayAug 20, 2025
Why won't my Toro Lawn Mower engine start?
- A
  amandagarciaAug 20, 2025
  Several factors can prevent your Toro Lawn Mower engine from starting. The fuel tank might be empty, so fill it. If your mower has a choke, ensure it's turned on. A dirty air cleaner can also be the culprit, so clean or replace it. Check that the spark plug wire(s) is properly connected, and the spark plug(s) isn't damaged or incorrectly gapped; replace if necessary. Also, ensure the fuel filter is clean; replace if dirty. Finally, ensure that the oil level in the crankcase is adequate; add oil if low.
R
Regina RivasAug 25, 2025
How to fix Toro Lawn Mower engine losing power?
- M
  mary68Aug 25, 2025
  If your Toro Lawn Mower engine is losing power, it could be due to several reasons. The engine load may be too high, so try reducing the ground speed. A dirty air cleaner can restrict airflow, so clean the air-cleaner element. Check the oil level in the crankcase and add oil if necessary. Also, ensure the cooling fins and air passages under the engine blower housing are free of obstructions. Finally, inspect the spark plug(s) and replace it if pitted, fouled, or incorrectly gapped.
J
Jon PearsonAug 26, 2025
How to fix uneven cutting height on my Toro TimeCutter 6000 Lawn Mower?
- H
  Heather ChandlerAug 26, 2025
  Uneven cutting height on your Toro Lawn Mower can be caused by several factors. Start by sharpening the blade(s). If a cutting blade(s) is bent, replace it with a new one. Ensure that the mower is level from side-to-side and front-to-rear. If your mower has an anti-scalp roller, make sure it's set correctly by adjusting the anti-scalp wheel height. Clean the underside of the mower deck. Finally, check and adjust the tire pressure.
E
Erica WashingtonAug 27, 2025
Why is my Toro TimeCutter 6000 engine overheating?
- T
  Troy BrownAug 28, 2025
  Several factors can cause your Toro Lawn Mower engine to overheat. First, the engine load might be excessive, so reduce the ground speed. Second, check the oil level in the crankcase and add oil if it is low. Third, obstructions in the cooling fins and air passages under the engine-blower housing can cause overheating; remove any obstructions. Fourth, a dirty air cleaner can contribute to the problem, so clean or replace the air-cleaner element. If the issue persists, there may be dirt, water, or stale fuel in the fuel system, in which case you should contact an Authorized Service Dealer.
M
Mary HannaAug 29, 2025
Why does my Toro TimeCutter 6000 Lawn Mower engine lose power?
- A
  Amanda WatsonAug 29, 2025
  If your Toro Lawn Mower engine loses power, consider the following potential causes: * The engine load may be too high; reduce the ground speed. * A dirty air cleaner can restrict airflow; clean the air-cleaner element. * Low oil level in the crankcase can cause power loss; add oil. * Blocked cooling fins and air passages under the engine blower housing can lead to overheating and power loss; remove any obstructions. * Faulty spark plug(s) (pitted, fouled, or with an incorrect gap) can reduce engine power; install a new, correctly gapped spark plug(s). For issues such as a blocked fuel-tank vent, dirt in the fuel filter, dirt, water, or stale fuel in the fuel system, or incorrect fuel in the fuel tank, contact an Authorized Service Dealer.
R
robert52Aug 31, 2025
What to do if my Toro Lawn Mower engine overheats?
- S
  shortbarbaraSep 1, 2025
  If your Toro Lawn Mower engine is overheating, there are several potential causes. First, the engine load might be excessive, so reduce the ground speed. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages under the engine-blower housing are free of obstructions. A dirty air cleaner can also cause overheating, so clean or replace the air-cleaner element.
A
Angela RodriguezSep 2, 2025
What to do if my Toro TimeCutter 6000 starter doesn't crank?
- R
  ruizrandallSep 2, 2025
  If the starter on your Toro Lawn Mower isn't cranking, first ensure that the blade-control switch is disengaged. Next, confirm that the motion-control levers are in the PARK position. If these aren't the issue, the battery may be dead, so charge it. Check the electrical connections for corrosion or looseness and correct them. Finally, inspect the fuse and replace it if blown.
D
david17Sep 4, 2025
Why is my Toro TimeCutter 6000 Lawn Mower vibrating so much?
- S
  Susan JimenezSep 4, 2025
  Abnormal vibration in your Toro Lawn Mower can stem from several issues. Check if the cutting blade(s) is/are bent or unbalanced; if so, install new cutting blade(s). Ensure the blade mounting bolt is tightened securely. Also, verify that the engine mounting bolts are not loose and tighten them if needed. Finally, make sure that the engine pulley, idler pulley, or blade pulley is tight.

Toro TimeCutter 6000 Specifications

General

Engine Type	Kohler 7000 Series
Transmission	Hydrostatic
Deck Type	Fabricated
Cutting Width	60 inches
Fuel Capacity	3.5 gallons
Cutting Height	1.5 - 4.5 inches

Related product manuals

Preview: Toro TimeCutter 6000 Series

Toro TimeCutter 6000 Series

Toro TimeCutter MX 6050

Toro TimeCutter HD MyRide 60in

Preview: Toro TimeCutter

Toro TimeCutter

Toro TimeCutter ZX

Toro TimeCutter Z420

Preview: Toro TimeCutter Z380

Toro TimeCutter Z380

Preview: Toro TimeCutter 4200

Toro TimeCutter 4200

Preview: Toro TimeCutter Z4200

Toro TimeCutter Z4200

Toro TimeCutter 75742

Toro TimeCutter 75748

Preview: Toro TIMECUTTER 74685

Toro TIMECUTTER 74685