To Next Page
N
Nathan GonzalezSep 10, 2025
What to do if my Toro TimeCutter 6000 Lawn Mower doesn't drive?
- EEmma FisherSep 10, 2025
If your Toro Lawn Mower isn't driving, the bypass valves may be open. Close the tow valves.
What to do if my Toro TimeCutter 6000 Lawn Mower doesn't drive?
If your Toro Lawn Mower isn't driving, the bypass valves may be open. Close the tow valves.
What to do if my Toro TimeCutter 6000 starter does not crank?
If the starter on your Toro Lawn Mower doesn't crank, check these items: * Ensure the blade-control switch is disengaged. * Make sure the motion-control levers are in the PARK position. * Check the battery and charge it if it's dead. * Inspect the electrical connections for corrosion or looseness and ensure good contact. * See if a fuse is blown and replace it if necessary. If a relay or switch is damaged, contact an Authorized Service Dealer.
Why is my Toro TimeCutter 6000 vibrating abnormally?
Abnormal vibration in your Toro Lawn Mower can stem from several issues. Start by checking the cutting blades for bending or imbalance; if found, install new cutting blades. Then, ensure the blade mounting bolt and engine mounting bolts are tightened securely. Also, inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley. For a damaged engine pulley, bent blade spindle, or loose/worn motor mount, contact an Authorized Service Dealer.
Why are the blades not rotating on my Toro Lawn Mower?
If the blades on your Toro Lawn Mower aren't rotating, several issues could be the cause. A worn, loose, or broken drive belt can prevent blade rotation, so install a new drive belt. Additionally, ensure the drive belt is properly installed on the pulley, checking the adjusting shafts and belt guides for correct positioning. If the power-takeoff (PTO) switch or PTO clutch is faulty, or the mower belt is worn, loose, or broken, contact an Authorized Service Dealer or install a new mower belt.
Why does my Toro Lawn Mower not drive?
If your Toro Lawn Mower won't drive, start by checking if the bypass valves are open and close the tow valves. For issues such as worn, loose, or broken traction belts, traction belts off the pulleys, or a failed transmission, contact an Authorized Service Dealer.
Why my Toro TimeCutter 6000 engine does not start?
If your Toro Lawn Mower engine doesn't start, starts with difficulty, or stalls, there are several potential causes: * The fuel tank might be empty, in which case you should fill it. * The choke (if applicable) may not be on; move the choke lever to the ON position. * A dirty air cleaner can cause this issue, so clean or replace it. * Check that the spark-plug wire(s) is securely connected to the spark plug. * The spark plug(s) may be faulty (pitted, fouled, or have an incorrect gap), so replace it with a new, correctly gapped one. * A clogged fuel filter can also be the culprit; replace it. * Ensure that the oil level in the crankcase is adequate, and add oil if it's low. If there is dirt, water, or stale fuel in the fuel system or incorrect fuel in the fuel tank, contact...
General| Engine Type | Kohler 7000 Series |
|---|---|
| Transmission | Hydrostatic |
| Deck Type | Fabricated |
| Cutting Width | 60 inches |
| Fuel Capacity | 3.5 gallons |
| Cutting Height | 1.5 - 4.5 inches |
