Lubrication
Greasing the Bearings
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
ARK position.
2. Shut off the engine and wait for all moving parts to stop before leaving the operating
position.
G451140
3. Clean the grease fittings with a rag.
Note: Scrape any paint off the front of the
fittings.
4. Connect a grease gun to each fitting.
5. Pump grease into the fittings until grease
begins to ooze out of the bearings.
6. Wipe up any excess grease.
Maintenance: Lubrication Page 5–5 3464-625 A
To Next Page
Loading...
