5-31
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Chassis
Park Brake Handle Assembly (Cont.)
Installation (Cont.)
2. With the park brake handle hardware oriented as shown, install the bolt through the brake detent (B) (Figure
39) and connect the ange nut. Torque to 200 ± 25 in-lbs. (23 ± 3 Nm).
3. Install the intermediate brake rod and secure with locking cotter pin.
4. Cycle the park brake lever to ensure that it locks in the engaged position.
5. Connect the battery terminals and verify proper function.
Figure 39
A. Torx Screw
B. Brake Detent
To Next Page
Loading...
