Toro TimeCutter SS 4250 - Page 42

3.Measurefromthetipofthebladetotheat
surface(Figure46).
g014973
Figure46
1.Blade(inpositionformeasuring)
2.Levelsurface
3.Measureddistancebetweenbladeandthesurface(A)
4.Rotatethesameblade180degreessothat
theopposingcuttingedgeisnowinthesame
position(Figure47).
g014974
Figure47
1.Blade(sidepreviouslymeasured)
2.Measurement(positionusedpreviously)
3.Opposingsideofbladebeingmovedintomeasurement
position
5.Measurefromthetipofthebladetotheat
surface(Figure48).
Note:Thevarianceshouldbenomorethan
3mm(1/8inch).
g014973
Figure48
1.Oppositebladeedge(inpositionformeasuring)
2.Levelsurface
3.Secondmeasureddistancebetweenbladeandsurface(B)
A.IfthedifferencebetweenAandBisgreater
than3mm(1/8inch),replacethebladewith
anewblade;refertoRemovingtheBlades
(page43)andInstallingtheBlades(page
43).
Note:Ifyoureplaceabentbladewitha
newbladeandthedimensionobtained
continuestoexceed3mm(1/8inch),the
bladespindlecouldbebent.Contactan
AuthorizedToroDealerforservice.
B.Ifthevarianceiswithinconstraints,moveto
thenextblade.
6.Repeatsteps1through5foreachblade.
42