Toro TITAN MX4880 - Adjusting the Anti-Scalp Rollers; Positioning the Seat; Adjusting the Motion Control Levers

AdjustingtheHeight-of-Cut
Theheight-of-cutcanbeadjustedfrom1-1/2to
4-1/2inch(38to114mm)in1/4inch(6mm)
incrementsbyrelocatingtheheight-of-cutpininto
differentholelocations.
1.Pushonthedeckliftpedalwithyourfootandraise
themowerdecktothetransportposition(also
the4-1/2inch(114mm)cuttingheightposition)
(
Figure28).
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure28).
3.Selectaholeintheheight-of-cutsystem
correspondingtotheheight-of-cutdesiredand,
insertthepin(
Figure28).
4.Pushonthedeckliftpedalwithyourfootandraise
theheight-of-cutleverslightlytodisengagethe
transportlock.Lowerthedeckslowlyuntilthepin
makescontactwiththelever.
G010236
1
2
3
4
5
Figure28
1.Deckliftpedal
4.Lockposition.lowest
height-of-cut(useonlyfor
deckremoval)
2.Cutheightpin
5.Lockposition.transport
position
3.Height-of-cutpositions
UsingtheLockPositions
Thedeckcanbelockedinthehighestheight-of-cutor
transportpositionorthelowestheight-of-cutposition.
Tolockthedeckinthetransportposition:
1.Pushonthedeckliftpedalwithyourfootand
raisethemowerdecktothetransportposition
(alsothe4.5inch(114mm)cuttingheightposition)
(Figure28).
2.Removethepinfromtheheight-of-cutbracket
(
Figure28).
3.Selectthelowerholeonthelockdecalandinsert
thepin(
Figure28).
Tolockthedeckinthelowestheight-of-cut
position:
1.Pushonthedeckliftpedalwithyourfootand
raisethemowerdecktothetransportposition
(alsothe4.5inch(114mm)cuttingheightposition)
(
Figure28).
2.Removethepinfromtheheight-of-cutbracket
(Figure28).
3.Pushonthedeckliftpedalwithyourfootandlower
themowerdecktothelowestposition..
4.Selecttheupperholeonthelockdecalandinsert
thepin(
Figure28).
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
1.Disengagethebladecontrolswitch(PTO),move
themotioncontrolleverstotheneutrallock
positionandsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
G010233
1
2
3
4
Figure29
1.Anti-scalproller3.FlangeNut
2.Bolt4.Holespacing
PositioningtheSeat
Theseatcanmoveforwardandbackward.Positionthe
seatwhereyouhavethebestcontrolofthemachine
andaremostcomfortable.
27