Toro TITAN ZX5000 - Mower Deck Adjustment Procedures; Setting Mower Deck Height-of-Cut; Using Mower Deck Lock Positions; Adjusting Anti-Scalp Rollers

G010016
G010219
Figure23
TransportLockPosition
AdjustingtheHeight-of-Cut
Theheight-of-cutcanbeadjustedfrom1-1/2to
4-1/2inch(38to114mm)in1/4inch(6mm)
incrementsbyrelocatingtheclevispinintodifferent
holelocations.
1.Pushonthedeckliftpedalwithyourfootandraise
themowerdecktothetransportposition(also
the4-1/2inch(114mm)cuttingheightposition)
(Figure24).
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure24).
3.Selectaholeintheheight-of-cutsystem
correspondingtotheheight-of-cutdesiredand,
insertthepin(Figure24).
4.Pushonthedeckliftpedalwithyourfootandraise
theheight-of-cutleverslightlytodisengagethe
transportlock.Lowerthedeckslowlyuntilthepin
makescontactwiththelever.
G010236
1
2
3
4
5
Figure24
1.Deckliftpedal
4.Lockposition.lowest
height-of-cut(useonlyfor
deckremoval)
2.Cutheightpin
5.Lockposition.transport
position
3.Height-of-cutpositions
UsingtheLockPositions
Thedeckcanbelockedinthehighestheight-of-cutor
transportpositionorthelowestheight-of-cutposition.
1.Pushonthedeckliftpedalwithyourfootandraise
themowerdecktothetransportposition(also
the4.5inch(114mm)cuttingheightposition)
(Figure24).
2.Removethepinfromtheheight-of-cutbracket
(Figure24).
3.Selectaholeonthelockdecalandinsertthepin
(Figure24).
4.Pushonthedeckliftpedalwithyourfootandraise
theheight-of-cutleverslightlytodisengagethe
transportlock.Lowerthedecktoslowlyuntilthe
pinmakescontactwiththelever.
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
1.Disengagethebladecontrolswitch(PTO),move
themotioncontrolleverstotheneutrallock
positionandsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
22