Toro TITAN ZX6000 - Page 42

g027477
Figure51
7.Locateandremovetheventplugoneach
transmission
8.Rotatetheltercounterclockwisetoremovethe
lter;allowoiltodrainfromdrivesystem.
Repeatthisprocedureforbothlters.
InstallingtheHydraulicSystem
Filters
ServiceInterval:Aftertherst50hours
Every400hours
1.Applyathincoatofoilonthesurfaceofthe
rubbersealofeachlter(Figure51).
2.Turnthelterclockwiseuntilrubberseal
contactsthelteradapterthentightenthelter
anadditional3/4to1fullturn(Figure51).
3.Repeatstep2fortheotherlter.
4.Alignthelterguardsovereachlter;referto
step4ofRemovingtheHydraulicSystemFilters
(page41).
5.Securethelterguardswiththe3screws
removedinstep4ofRemovingtheHydraulic
SystemFilters(page41).Usethe3screwsto
securethelterguards.
6.Addoiltothehydraulicsystemasfollows:
A.Ensurethattheventplugsandreservoircap
areremovedbeforeaddingtheoil(Figure
49andFigure50).
B.Slowlypourthespeciedoilthrough
expansionreservoiruntiloilcomesoutof
oneoftheventplugholesandstoplling
(Figure50).
C.Installthatventplug(Figure50).
Note:T orquetheplugto20.3N-m(180
in-lb).
D.Addoilthroughtheexpansionreservoiruntil
oilcomesoutoftheremainingventplug
holeonthesecondtransmissionandstop
lling(Figure50).
E.Installthatventplug(Figure50).
Note:T orquetheplugto20.3N-m(180
in-lb).
7.Addoilthroughtheexpansionreservoiruntil
itreachestheFullColdlineontheexpansion
reservoirandinstallthecapforthereservoir
(Figure49).
8.Bleedthehydraulicsystem;refertoBleeding
theHydraulicSystem(page43).
Important:FailuretoperformtheBleeding
theHydraulicSystemprocedureafter
changinghydraulicltersandoilmayresult
inirreparabledamagetothetransaxledrive
system.
42