Toro Z Master Professional 7000 Series - Replacing the Hydraulic Filter and Fluid

5.Ifthereisnouid,adduidtothereservoiruntil
itreachesthecoldlevelofthebafe.
6.Runthemachineatlowidlefor15minutesto
allowanyairtopurgeoutofthesystemand
warmtheuid;refertoStartingandShuttingOff
theEngine(page26).
Note:Checktheuidlevelwhiletheuidis
warm.Theuidshouldbebetweencoldandhot.
7.Ifrequired,adduidtothehydraulictank.
Note:Theuidlevelshouldbetothetopof
thehotlevelofthebafe,whentheuidishot
(Figure98).
8.Installcaponllerneck.
g004819
Figure98
1.Hotuidlevel-full2.Colduidlevel-full
ReplacingtheHydraulicFilterand
Fluid
ServiceInterval:Aftertherst25hours
Every250hours—Changethehydrauliclter
andhydraulicuidwhenusingMobil
®
1uid.
Every500hours—Changethehydraulic
lterandhydraulicuidwhenusingToro
®
HYPR-OIL
™
500hydraulicuid.
Usesummerlterabove0°C(32°F)
Usewinterlterbelow0°C(32°F)
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch,andengagetheparking
brake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
Important:Donotsubstituteautomotive
oillterorseverehydraulicsystemdamage
mayresult.
3.Placedrainpanunderlter,removetheoldlter
andwipethelteradaptergasketsurfaceclean
(Figure99).
g001044
Figure99
1.Hydrauliclter
4.Removetherighthydrauliclinethatcomesinto
theadapter(Figure100).
5.Allowtheuidtodrainoutofthesystemintothe
drainpan.
6.Installtherighthydrauliclinetotheadapter
(Figure100).
67