Introduction
13
Inserting batteries
Aim the remote control at the remote sensor and press the control buttons to operate. Make sure the remote control
is within approximately five meters and 30° angle (on either side) of the remote sensor.
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new
ones.
• When replacing the remote control batteries, always replace both batteries with new ones. Never mix battery types or
use new and used batteries in combination.
• Always remove batteries from remote control if they are already drained or if the remote control is not to be use for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.
N
Open the battery compartment
cover in the direction of the
arrow.
O
Install two “R03/AAA” batteries
(supplied), paying attention to
the polarity indicated in the
battery compartment.
P
Replace the compartment cover.
Operation
To Next Page
Loading...
Need help?
General
