Toshiba 3000 PROFIBUS - Registration and Setup; Registration and Setup Procedure

6F8C0921
21
6
Chapter 6 Registration and Setup
This chapter describes the registration and setup method when connecting PROFIBUS
to an S controller. The Engineering tool (Ver. 1.85 or later) is used for registration and
setup.
6.1 Registration and Setup Procedure
The basic registration and setup procedure is as follows. In order to register and setup
PROFIBUS, you must create folders for the target systems, stations, and controllers.
Figure 6-1 Registration and setup procedure
The content of the registration and setup screen depends on the version of the
engineering tool.
Refer to the registration and setup procedure in the Appendix for details.
START
(1) Register the PROFIBUS module in the
hardware configuration in the station folder.
(2) Register the LAN to be used
(PROFIBUS) in the system configuration.
(3) Use Scan symbol editor 2 to assign
cyclic memory and S controller variables.
(4) Check that I/O connections are
assigned to I/Q registers.
End