43
CONTROLS AND FEATURES
English
Setting up the Network
You can select the Network Type.
a Press MENU / C c to highlight Setup icon.
b Press B / C c to highlight Preferences icon and
press OK.
c Press B or b to select Network Setup and press OK.
NOTE: If the Dual Band WLAN Adaptor is not
connected, Wireless cannot be selected.
d Press B or b to select Network Type, and then press
C or c to select Wired or Wireless.
e If you selected Wired, see “Advanced Network Setup”
on page 45.
NOTE:
• This feature is grayed out when the Dual Band WLAN
Adaptor is not connected or Network Type is set to Wired.
• When you insert or remove the wireless LAN adaptor, you
must turn off your TV and unplug the power cord, and then
plug and turn on again.
• Continued connection of AP (Access Point) is not guaranteed.
The connection may be disconnected while watching TV.
• Do not remove the Dual Band WLAN Adaptor when
Network Type is set to Wireless or wireless
communication is active.
There are 3 methods for Wireless Setup:
Easy Setup (WPS)
If the AP supports WPS, this method can be used.
• WPS is an industry standard designed to make connection
of wireless LAN equipment and security setup easy. WPS
will automatically configure all wireless settings.
Assisted Setup (setup by using the AP’s notification
information)
Network Name, Authentication, and Encryption are decided
based on information from the AP. You will manually set the
Security Key.
Manual Setup (manual input of all settings)
Easy Setup using PBC (Push Button Configuration)
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Easy Setup and press OK.
d Press C or c to select PBC.
e Press b to highlight Start Scan and press OK.
f Following the on-screen instructions, push the
appropriate button on your AP.
g When a window reporting that the setup is complete
appears, press OK.
To cancel searching for the AP:
Press BACK while searching for the AP. A message will
appear, and then press C or c to select Yes and press
OK.
Easy Setup using PIN (Personal Identification Number)
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Easy Setup and press OK.
d Press C or c to select PIN.
e Press b to select Start Scan and press OK.
f Press B or b to select the desired AP and press OK.
NOTE: Check the MAC address on the label of the AP
or in the manual, and select your AP.
g When the PIN code window appears, enter the
displayed PIN into your AP, and then press Next to
continue the PIN Setup. When a message displays to
report that the setup is complete, press OK.
Wireless Setup
To Next Page
Loading...
