Toshiba 50L9450 Series - Page 25

25
Using the TV’s features
2 Press  or  to select Picture Mode.
Standard
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster Middle
0
0
0
0
70
100
3 Press  or  to select your desired Picture
Mode.
NOTE:
The Picture Mode you select a ects the current input
only. You can select a di erent Picture Mode for each
input.
Activating the picture preferences
You can customise current Picture Mode settings as
desired. For example, while selecting "Dynamic", if
you change the following items, such as Backlight,
Contrast, Brightness, Colour, Tint, Sharpness, and
the Picture Settings items, your new setting are
saved for "Dynamic" Picture Mode.
1 From the Picture Settings menu, press 
or  to select either Backlight, Contrast,
Brightness, Colour, Tint or Sharpness.
2 Press  or  to adjust the settings as desired.
Setting the Contrast Booster
Contrast Booster improves the de nition of dark
areas of the picture.
1 From the Picture Settings menu, press  or 
to select Contrast Booster.
Standard
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster Middle
0
0
0
0
70
100
2 Press  or  to select Middle, High, O or
Low.
Adjusting the Colour Temperature
Colour Temperature increases the warmth or
coolness of the picture by setting the red, green or
blue tint.
1 From the Picture Settings menu, press  or 
to select Colour Temperature, then press OK.
2 Press  or  to select Auto, Cool, Natural, or
Warm to suit your preference.
Cool
Colour Temperature
Colour Temperature
Red Level
Green Level
Blue Level
Reset
0
0
0
3 Press  or  to select Red Level, Green Level
or Blue Level, then press  or  to adjust the
setting as required.
Resetting the Colour Temperature
This function resets your colour temparature
settings to the factory settings.
1 From the Colour Temperature menu, press 
or  to select Reset, then press OK.
2 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
1 From the Picture Settings menu, press  or 
to select Noise Reduction, and then press OK.
On
Auto
Auto
Noise Reduction
Auto Clean
MPEG NR
DNR
2 Select Auto Clean, and then press  or  to
select On or O .
O mode :
MPEG NR menu and DNR menu are available.
• MPEG NR mode: Low, Middle, High or O
• DNR (Digital Noise Reduction) mode: Low,
Middle, High or O
506584L9450SeriesEn.indd25506584L9450SeriesEn.indd25 2014/08/2114:23:462014/08/2114:23:46