Toshiba B-EP4DL-GH32-QM-R - Attaching Accessories; Belt Clip Installation; Shoulder Strap Attachment

8
How to Attach the Accessories

Belt clip
When you use the printer fixing to your belt, secure
the supplied belt clip to the printer back.
1. Secure the belt clip to the printer back with the two
screws.
NOTE:
Only use the supplied screw to secure the belt clip.
Use of other screw may damage the printer inside.
2. Fasten the belt clip to your belt.
 Shoulder strap (option)
Use the following procedure to fasten an optional
shoulder strap (B-EP900-SS-QM-R) to the printer.
1. Pass either end of the shoulder strap through the
strap slot of the printer as shown in the figure
below.
2. Pass the end of the shoulder strap through the
buckle. Slide the buckle to adjust the length of the
shoulder strap.
3. Do the same to the other end of the shoulder
strap.
Shoulder
strap
Buckle
CAUTION!
1. Care should be taken not to drop the printer when securing it to your waist or slinging it over your shoulder.
2. For fixing the printer to your belt, the belt width should be 40 mm or less.
The use of the other belts may cause the printer to fall.
Strap
slot
M
-3x8 screw
Belt
clip
Belt
clip
Belt