Why is the media not feeding in my Toshiba Barcode Reader?
If the media is not feeding in your Toshiba Barcode Reader, it could be due to: 1. The media not being loaded properly. 2. The printer being in an error condition. To resolve this: 1. Load the media properly. 2. Solve the error shown in the message display.
How to resolve blurred printed images on my Toshiba Barcode Reader?
If the printed image from your Toshiba Barcode Reader is blurred, it might be because: 1. The ribbon and media are not matched correctly. 2. The Print Head is not clean. To fix this: 1. Select an appropriate ribbon for the media type you are using. 2. Clean the print head using a Print Head Cleaner or a cotton swab slightly moistened with ethyl alcohol.
How to fix a Toshiba Barcode Reader that will not turn on?
If your Toshiba Barcode Reader is not turning on, here are a few things to check: 1. Make sure the Power Cord is properly plugged in. 2. Test the AC outlet with another electrical appliance to ensure it's functioning correctly. 3. Check the fuse or circuit breaker.
Why does my Toshiba Barcode Reader say 'COMMS ERROR'?
If you're encountering a 'COMMS ERROR' on your Toshiba Barcode Reader, it means a communication error has occurred. To resolve this, ensure that the interface cable is correctly connected to both the printer and the host, and verify that the host is turned on.
What to do if my Toshiba Barcode Reader displays 'NO PAPER'?
If your Toshiba Barcode Reader shows a 'NO PAPER' error, it could be due to these reasons: 1. The media has run out. 2. The media is not loaded properly. 3. The media is slack. To fix this: 1. Load new media and press the [RESTART] key. 2. Reload the media correctly and press the [RESTART] key. 3. Take up any slack in the media.
What does 'SYNTAX ERROR' mean on my Toshiba Barcode Reader?
If your Toshiba Barcode Reader displays 'SYNTAX ERROR', turn the printer off, and then on again. This error occurs when the printer receives an improper command during firmware upgrade download mode.
General| Print Technology | Thermal Transfer / Direct Thermal |
|---|---|
| Print Resolution | 203 dpi, 300 dpi |
| Print Speed | Up to 152.4 mm/sec (6 ips) |
| Max. Print Width | 104 mm (4.09") |
| Interfaces | Serial, USB |
| Optional Interfaces | Wireless LAN, Bluetooth |
| Barcodes | Code 39, Code 128 |
| 2D Codes | Data Matrix, PDF417, QR Code |
| Media Width | 25.4 mm to 112 mm |
| Media Thickness | 0.06 mm |
| Media Roll Diameter | Max. 127 mm |
| Ribbon Width | 40 – 110 mm |
| Ribbon Length | 300 m |
| Power Supply | 100-240 VAC, 50/60 Hz |
Essential warnings and cautions for safe handling and maintenance of the printer.
Step-by-step guides for loading media and ribbon into the printer.
Setting operating environment, parameters, and system modes for printer operation.
Performing test prints and fine-tuning print start position, tone, and settings.
Setting sensor thresholds for accurate print positioning using auto/manual methods.
Routine cleaning for print head, platen, sensors, covers, and optional modules.
Comprehensive list of printer error messages, their causes, and resolutions.
To Next Page