APPENDIX 1 MESSAGES AND LEDS ENGLISH VERSION EO1-33048
APPENDIX 1 MESSAGES AND LEDS
EA1- 1
APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
4: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LED Indicatio
Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE
z
Online mode ----- Yes
1
ON LINE
~ z
Online mode (communicating) ----- Yes
2
HEAD OPEN
z z
The Top Cover is opened in online mode. ----- Yes
3
PAUSE ****
z z
Pause state Yes Yes
4
COMMS ERROR
z
A parity, overrun, or framing error has
occurred during a communication by RS-
232C.
Yes Yes
5
PAPER JAM ****
z
A paper jam has occurred during paper
feed.
Yes Yes
6
CUTTER ERROR****
z
A problem has occurred at the cutter
module.
Yes Yes
7
NO PAPER ****
z
The media has run out, or the media is not
loaded properly.
Yes Yes
8
HEAD OPEN ****
z
A feed or an issue was attempted with the
Top Cover opened. (Except when the
[FEED] key is pressed.)
Yes Yes
9
HEAD ERROR
z
The print head has a problem. Yes Yes
10
EXCESS HEAD TEMP
z
The print head is overheated. No Yes
11
RIBBON ERROR****
z
• The ribbon has run out.
• The ribbon has been torn. A problem has
occurred with the sensor that determines
the torque for the ribbon motor.
Yes Yes
12
COVER OPEN ****
z
A feed or printing was attempted with the
Front Cover opened.
Yes Yes
13
SAVING ####&&&&
z
In writable character or PC command save
mode
----- Yes
14
FLASH WRITE ERR.
z
An error has occurred in writing to the flash
ROM.
No Yes
15
FORMAT ERROR
z
An error has occurred in formatting the
flash ROM.
No Yes
16
FLASH CARD FULL
z
Saving failed because of an insufficient
capacity of the flash ROM.
No Yes
17
Display of error
message (See Note.)
z
A command error has occurred in analyzing
the command.
Yes Yes
18 POWER FAILURE z A momentary power failure has occurred. No No
19 INTIALIZING… z z The flash ROM is being initialised. ----- -----
20 EEPROM ERROR z
Data cannot be read from/written to a
backup EEPROM properly.
----- -----
To Next Page
Loading...
