Toshiba B-SA4TP SERIES - Page 86

2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.10 Position and Print Tone Fine Adjustment
E2-72
2.10 Position and Print
Tone Fine
Adjustment (Cont.)
When the ribbon is slack or wrinkled and printing is affected, fine adjust
the ribbon motor torque by using the following procedure.
Take-up Motor (RBN ADJ <FW>)
After selecting a fine adjustment value or to skip this menu, press the
[PAUSE] key.
Feed Motor (RBN ADJ <BK>)
After selecting a fine adjustment value or to skip this menu, press the
[PAUSE] key.
Ribbon Motor Voltage Fine Adjustment
[RESTART]
[FEED]
RBN ADJ<FW> +2
RBN ADJ<FW> +1
RBN ADJ<FW> +0
RBN ADJ<FW> -14
RBN ADJ<FW> -15
Motor Torque
High
Low
<3>ADJUST SET
RBN ADJ<FW> -10
RBN ADJ<BK> +10
RBN ADJ<BK> +9
RBN ADJ<BK> +8
RBN ADJ<BK> -14
RBN ADJ<BK> -15
Motor Torque
High
Low
[RESTART]
[FEED]
<3>ADJUST SET
RBN ADJ<BK> -5
NOTES:
Choose a desired value by using the
[RESTART] or [FEED] key.
P
ressing the [FEED] key one time
causes a –1 step change, up to
–
15 steps.
P
ressing the [RESTART] key one
time causes a +1 step change, up to
+2 steps.
NOTES:
Choose a desired value by using the
[RESTART] or [FEED] key.
P
ressing the [FEED] key one time
causes a –1 step change, up to
–
15 steps.
P
ressing the [RESTART] key one
time causes a +1 step change, up to
+10 steps.