2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.4 Loading the Media
E2- 9
2.4 Loading the Media
(Cont.)
Cut mode (Option)
When the optional Cutter Module is fitted, the media is automatically cut.
A swing cutter and a rotary cutter are available as an option, but they are
used in the same way.
Insert the leading edge of the media into the Media Outlet of the Cutter
Module.
13. If the loaded media is direct thermal media (a chemically treated
surface), the media loading procedure is now completed. Close the
Ribbon Shaft Holder Plate, and turn the Head Lever to Lock
position to close. Then, close the Top Cover.
If the media is thermal transfer media, it is also necessary to load a
ribbon. Refer to Section 2.5 Loading the Ribbon.
Media Outlet
Media
Cutter Module
CAUTION
1. Be sure to cut the backing
paper of the label. Cutting
labels will cause the glue to
stick to the cutter which
may affect the cutter qualit
and shorten the cutter life.
2. Use of tag paper when the
thickness exceeds the
specified value may affect
the cutter life.
The cutter is sharp, so care
must be taken not to injure
yourself when handling the
cutter.
WARNING!
To Next Page
Loading...
