2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.9 Setting an Operating Environment
E2-31
2.9.1 Parameter Setting
(Cont.)
(28) Reverse Feed Speed Selection
This parameter is to choose a reverse feed speed.
In the strip issue, the back feed speed of 3”/sec. may cause a shortage of
feed amount due to a lack of torque, slippery media surface, etc. In such
case, reduce the back feed speed to 2”/sec. to secure the feed amount.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Back Feed Speed, press the [PAUSE] key.
(29) Maxi Code Specification Selection
This parameter is to choose a Maxi code specification.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Maxi code specification, press the [PAUSE] key.
<2>PARAMETER SET
BACK SPEED STD
BACK SPEED STD
BACK SPEED LOW
[RESTART]
[FEED]
STD: 3 inch/second
LOW: 2 inch/second
<2>PARAMETER SET
MAXI CODE TYPE1
MAXI CODE TYPE1
MAXI CODE TYPE2
[RESTART]
[FEED]
TYPE1: Compatible specification
with the B-X series
TYPE2: Specification for specific
home delivery company
To Next Page
Loading...
