7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33056
7.1 Media
E7- 1
7. SUPPLY SPECIFICATIONS
7.1 Media
Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a
problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service
representative.
7.1.1 Media Type
Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table
below shows size and shape of the media available for this printer.
[Unit: mm]
Label dispensing mode
Item
Batch mode Strip mode Cut mode
Label 10.0 – 1709.0 25.4 – 1709.0 38.0 - 1709.0
c Media pitch
Tag paper 10.0 – 1709.0
----- 25.4 – 1709.0
d Label length 7.5 – 1707.0 22.9 – 1707.0 25.0 – 1703.0
e Media width/backing paper width 84 – 175.0 101.6 – 175.0
f Label width 81.0 – 172.0
g Gap length 2.5 – 20.0 2.5 – 20.0 6.0 – 20.0
h Black mark length (Tag paper) 2.5 – 10.0
i Maximum effective print width 10.0 – 170.6
Label 5.5 – 1705.0 20.9 – 1705.0 23.0 - 1705.0
j Effective print length
Tag paper 8.0 – 1705.0
----- 23.4 – 1705.0
k Print speed up/slow down area 1.0
Label 0.13 – 0.17
Thickness
Tag paper 0.1 – 0.17
Maximum outer roll diameter Ø200
Roll direction Inside
Inner core diameter Ø76.2±0.3
Label Tag paper
Cut position
Cut position
Stop
position
Stop
position
Feed Direction
Black Mark
(on reverse side)
Black Mark
(on reverse side)
h
e
c
e
g
h
c
d
i
i
k
k
f
j
To Next Page
Loading...
