How do I resolve 'FLASH WRITE ERR.' on my Toshiba BA410T-TS12-QM-S?
The 'FLASH WRITE ERR.' message on your Toshiba Barcode Reader indicates an error occurred while writing to the flash ROM. To resolve this, turn the printer off and then on again.
What causes a 'CUTTER ERROR' on my Toshiba BA410T-TS12-QM-S?
A 'CUTTER ERROR' on your Toshiba Barcode Reader (when an optional cutter module is installed) means the media is jammed in the cutter. Remove the jammed media and then press the [RESTART] key.
What should I do if my Toshiba BA410T-TS12-QM-S Barcode Reader indicates 'POWER FAILURE'?
A 'POWER FAILURE' message on your Toshiba Barcode Reader indicates a momentary power failure. Check the power source supplying power to the printer. If the rating is incorrect, or if the printer shares the same power outlet with other electrical appliances that consume large amounts of power, change the outlet.
What to do if my Toshiba Barcode Reader shows 'HEAD OPEN' error?
The 'HEAD OPEN' error on your Toshiba Barcode Reader indicates that the Top Cover is opened in Online mode or a feed/issue was attempted with the Top Cover open. To resolve this, close the Top Cover and then press the [RESTART] key.
Why does my Toshiba BA410T-TS12-QM-S show a 'COMMS ERROR'?
A 'COMMS ERROR' on your Toshiba Barcode Reader indicates a communication error. Ensure the interface cable is correctly connected to both the printer and the host, and verify that the host is turned on.
How to fix 'No Paper' error on Toshiba Barcode Reader?
If your Toshiba Barcode Reader displays a 'No Paper' error, it could be due to a few reasons: * The media has run out. Load new media and then press the [RESTART] key. * The media is not loaded properly. Reload the media correctly and then press the [RESTART] key. * The media is slack. Take up any slack in the media.
Why does my Toshiba BA410T-TS12-QM-S display 'SYNTAX ERROR'?
A 'SYNTAX ERROR' on your Toshiba Barcode Reader indicates that, while in Download mode for upgrading the firmware, the printer received an improper command. Turn the printer off, and then on again.
General| Model | BA410T-TS12-QM-S |
|---|---|
| Type | Barcode Reader |
| Scanning Technology | Laser |
| Resolution | 203 dpi |
| Maximum Print Width | 104 mm |
| Connectivity | USB |
| Print Method | Direct Thermal / Thermal Transfer |
| Supported Barcodes | 1D barcodes |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 25% to 85% non-condensing |
| Interface | USB, Ethernet |
Covers printer installation and power connection procedures.
Instructions for loading media (labels/tags) and ribbons.
Steps for connecting to a host computer and turning the printer on.
General guidance on routine maintenance and cleaning schedules for the printer.
Lists common error messages, their causes, and recommended solutions.
Addresses common operational problems and their solutions.
Step-by-step guide for safely removing jammed media from the printer.
To Next Page