1 PREPARATION
28 Description of Each Component
Description of Each Component
Front / Right side
1. Platen Cover (optional, KA-1640PC)
Place an original on the original glass and start copying with this cover closed.
2. Reversing Automatic Document Feeder (optional, MR-3019) / Automatic Document
Feeder (optional, MR-2017)
A stack of originals placed on this are scanned one sheet after another. Maximum 100
sheets (or stack height 16 mm) of originals can be placed in one go. (The maximum number
of sheets can be placed may vary depending on the media type of the originals.) 2-sided
originals can be scanned with the Reversing Automatic Document Feeder (MR-3019).
P.56 “Placing originals on Reversing Automatic Document Feeder (optional) / Automatic
Document Feeder (optional)”
P.174 “Paper jams within Reversing Automatic Document Feeder (optional) / Automatic
Document Feeder (optional)”
3. Operator’s Manual Pocket (Back side) (optional, KK-1660)
Keep the Operator’s Manual in this.
4. Side cover
5. Automatic Duplexing Unit (optional, MD-0103)
Install this to make it possible to print on both sides of paper.
6. Bypass tray
Use this to make copies on special media types such as thick paper, overhead transparen-
cies or tracing paper.
P.61 “Using Bypass Tray”
P.177 “Paper jams on bypass tray”
2
1
3
4
5
6
7
8
9
10
11
12
13
To Next Page
Loading...
