2.COPY FUNCTIONS
Basic Copy Procedure 33
2 COPY FUNCTIONS
3
Enter the number of copies with the digital keys.
4
Make the copy settings as required.
P.36 “Copy Settings”
You may not be able to use some combinations of functions.
P.134 “Copying Function Combination Matrix”
5
Press [START] to start copying.
To stop or resume copying, press [CLEAR/STOP] during copying.
Press [OK] or [CANCEL] according to the message displayed on the LCD screen.
When the copying has finished, press [FUNCTION CLEAR] to clear the set copy functions and return to the main
screen (Copy).
If the paper source runs out of paper, an error message is displayed on the LCD screen and copying stops. Load
paper. The equipment automatically resumes copying after approx. 3 seconds have passed.
The receiving tray can hold up to 100 sheets. If the excessive paper error occurs, the lamp blinks and an error
message is displayed on the LCD screen. Remove the paper from the tray and press [START] to resume copying.
When you use overhead transparencies, remove them one by one every time they are ejected. Otherwise, they
could be curled and not be good for projection.
To Next Page
Loading...
