e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 5
3. Printer-specific Adjustments
3.3 To Obtain the Desired Color Balance
Before the adjustment After the adjustment
–
The natural color balance is obtained. The desired color balance is obtained.
(Ex. Yellowness is enhanced.)
Explanation
If you would like to change the color balance or darkness of the printouts and reproducibility of halftones in
accordance with a type of original or the user’s requirements, change the "Image Quality Type" option on the
printer driver or adjust the color balance.
Procedures
* Perform the adjustment in accordance with the procedures below.
* Both the service technician and the user can use procedures (1) and (2).
* Only the service technician must use procedure (3).
To Next Page
Loading...
